Program: 48 Shearwater Esplanade Runaway Bay QLD 4216

Safety Notice Board

SITE LOCATION: 48, Lot 92 on RP145646 Shearwater Esplanade, RUNAWAY BAY QLD 4216ALL WORKERS & VISITORS MUST BE INDUCTED TO SITESite Manager: Matthew Hunter | Contact Phone: 0431 677 756Site Administration: Anthony Painter | Contact Phone: 0484 926 708In case of emergency please dial 000

SAFETY NOTICE – BASEMENT DEWATERING

Important: Protect Your EquipmentDuring active dewatering operations, do not store plant, equipment, tools or valuables in the basement area.In the event of a power failure, there will be a delay before backup generation is operational. During this interval, salt water ingress may occur.To avoid damage, please ensure all items you do not wish to be exposed to salt water are stored outside the basement area until further notice.Thank you for your attention to this matter (not DJT).

Emergency Muster Points

Inquiries/Hazard Reporting Form

SITE SAFETY

Before starting/entering site:

1. Contractors, submit your pre-qual information

2. Contractors or visitors, complete a site induction

Pre-Qualification Form

Site Induction Form

Construction Workplace Plan

Visitor Site Induction Q&A

ANSWER 1

  1. Visitors are required to sign in at the site office to ensure safety & compliance while on site.
  2. Must be done prior to work commencing onsite.
  3. Site personnel to conduct site induction via Ipad located in site office.

ANSWER 2

  1. Stop work immediately & evacuate the area safely.
  2. Assist others if it is safe to do so.
  3. Site personnel to conduct site induction via Ipad located in site office.
  4. Provide first aid if trained and appropriate.
    5. Contact emergency services if required.
  5. Proceed to the designated assembly point.

ANSWER 3

  1. Stop work and make the area safe.
  2. Notify the Site Manager - Matthew Hunter (0431677756) or Site Administration - Anthony Painter (0484926708) immediately.
  3. Contact emergency services if required: 000 (landline) or 112 (mobile)
  4. Proceed to a designated assembly/muster point.

ANSWER 4

  1. Front/Road side: https://w3w.co/rifled.tiring.surfacing
  2. Back/Canal side: https://w3w.co/simulator.obtain.hairpins
  3. Remain at the assembly point until instructed otherwise.

ANSWER 5

  1. First aid equipment is located in the site storage container marked with a green cross.
  2. Do not access first aid supplies without authorisation.
  3. Contact trained first aid personnel if an injury occurs - Lissy Alvaran (0422252379)
  4. Call an ambulance if required.
  5. Notify site management of all injuries and incidents.

ANSWER 6

  1. Proceed to the designated assembly point when safe to do so.
  2. Follow directions from site management and/or emergency services personnel.

ANSWER 7

  1. Wear mandatory PPE before entering the work area.
  2. Minimum PPE includes:
  3. Available at site office: Hard hat - Safety glasses - High-visibility vest/clothing - Hearing protection
  4. Other: Enclosed safety footwear - Long-sleeve shirt

ANSWER 8

  1. Ensure all PPE is worn correctly and is suitable for the task.
  2. Replace damaged or defective PPE immediately.
  3. Maintain PPE in good condition at all times.

ANSWER 9

  1. Do not enter barricaded/flagged or taped off exclusion zones.
  2. Be aware of key site hazards, including: Working at heights - Electrical hazards - Excavations and trenches - Hazardous substances - Mobile plant and vehicle movements - Public protection and site access controls

ANSWER 10

  • Visitors are encouraged to ask questions before/during and after the visitor induction to make sure all instructions are clear.